Kaiping Jenor Sanitary Ware Co., Ltd[Guangdong,China] Business Type: ManufacturerMain Markets: Africa , Asia , East Europe , Europe , Middle East , North Europe , Oceania , Other Markets , West Europe , WorldwideExporter: 91% - 100%Certs: ACS, CE, ISO9001
1. First, insert the hose into the faucet and connect it. Then connect the screw rod to the faucet interface, put the rubber ring on the faucet, then extend the faucet into the basin, and add rubber pads and gaskets. Then use a wrench to hold the screw in place.
2. Since the Basin Faucet is a hot and cold water faucet, the internal water valve is a three-way, and there is only one water inlet, so only one hose can be connected. The other hose has to be connected to the faucet, but the other end has to be blocked. The editor consulted the owner of the hardware store, and he recommended sealing it with a wire plug. In addition, as mentioned earlier, the hose of the faucet is only 50 cm, but the actual need is about 60 cm, so I chose a matching 60 cm hose at the hardware store, wrapped it with a raw material tape, and connected it.
3. At this point, the disassembly and installation of the basin faucet is completed, and the rest is some cleaning and glue work.
